Learning and Applying Solidworks 2007 - 2008step by step

Back

FOR RELEASES 2003-2004 THROUGH 2007-2008.

This unique reference was written with the intention that users can learn Solidworks on their own with little or no outside help. Unlike other books of its kind, it begins at a very basic level and ends at a fairly advanced level. It’s perfect for anyone enrolled in Engineering and Technology programs, as well as professionals interested in learning Solidworks. It applies to Solidworks releases 2003 – 2008.

FEATURES

•         Provides step-by-step instructions along with numerous illustrations.

•         Commands are shown in bold for those who would rather not read every word of instruction.

•         Includes graphic illustration for each step for those who would rather learn visually.

•         Contains small notes on most illustrations to further clarify instructions.

CONTENTS

•         Getting Started

•         Create a simple sketch using the Sketch command

•         Dimension a sketch using the Smart Dimension command

•         Extrude a sketch using the Features command

•         Create a fillet using the Fillet command

•         Create a hole using the Extrude command

•         Create a counter bore using the Hole command

•         Learning More Basics

•         Revolve a sketch using the Revolve command

•         Create a hole using the Extrude command

•         Create a series of holes using the Circular Hole command

•         Learning to Detail Part Drawings

•         Create an Orthographic View using the Drawing commands

•         Advanced Detail Drawing Procedures

•         Create an Auxiliary View using the Drawing commands

•         Create a Section View using the Drawing commands

•         Dimension views using the Drawing commands

•         Create Text using the Drawing Annotation Panel

•         Learning to Edit Existing Solid Models

•         Edit the part using the Sketch commands

•         Edit the part using the Extrude command

•         Edit the part using the Chamfer command

•         Advanced Design Procedures

•         Learn to use the Front, Top, and Right Planes

•         Learn to use the Wireframe viewing command

•         Learn to Convert Entities on to a new sketch

•         Learn to use the Shell command

•         Introduction to Assembly View Procedures

•         Learn to insert existing solid models into the Assembly commands

•         Learn to constrain all parts using the Mate command

•         Learn to edit/modify parts while in the Assembly command

•         Learn to assign colors to different parts in the Assembly command

Learn to drive constraints to simulate motion